Mercedes Benz Series 107 Bodywork Repair Manual
(1972 - 1989) 280 - 300 - 350 - 380 - 420 - 450 - 500 - 560 SL & SLC
Roadster's and Rally Coup's
Mercedes Benz General Bodywork Repair Manual, R107 C107 SL & SLC + FRAME DIAGRAM
Download Mercedes 107 Bodywork Manual
Zoom in to view, or print any page or diagram.
Just $9.95
Download Link Emailed To Your Paypal Email Address
 |
 |
 |
BODYWORK REPAIR + FRAME DIAGRAM
107 R107 C107 Series US and European 280 300 380 420 450
500 560
ROADSTER & COUPE
BODYWORK REPAIR by Mercedes-Benz 107 Models 1972-1989:
This information is offered as a
Specialized Literature Item from:
Workshop Repair, Unit Manual
"Bodywork", Vol.1, including all Supplements (in JG 60-64):
- Supl. #1 - Extension - December 1971
- Supl. #5 - Revision - September 1973
- Supl. #5 - Extension - September 1973
- Supl. #7 - Revision - July 1974
- Supl. #8 - Revision - February 1975
- Supl. #9 - Revision - November 1975
- Append - B60/72 B16 - 560SL 107.048 Changes
See specific work in action :
- Rear floor being replaced
- Detailed repair of front end components
- Replace / repair rear fender & related areas
- Rear fender light surrounds & related areas
- Side member attachment to front wall details
- Clear details of illustrationsCommon rusted areas below windshield
Support, Inspect, measure, & determine job scope.
Determine structure names, part numbers & sub-component structures part #'s if needed...
Determine safe, effective support points best for the work to be done
Use this information to show you where to place the supports you have.
Whether supporting, straightening or aligning, a shop dolly and/or well-placed jack & wood-blocks
go a long way.
Measure, cut or straighten, prep, align, bolt or weld
Replace rusted panels, quarter- panels, side members, supports, or entire body sections
Cut, grind, prep & spot weld, bead weld, plug weld, & finish all sections & components,
rusted floor, side members, panel & pillar sections. all!
A good jack and few blocks of wood go a long way when you know where to put'em.
Front wall (under windshield) work
Penetration point identification, closing washer & rubber plug locations & all part numbers
Replace corroded doors, rocker panel sections, wheel wells, rear floorings, bumpers & other structural members.
Replace cowl, add penetrations, close & seal un-needed penetrations
SAVE BIG $$$$$$ IN REPAIR AND MAINTENANCE COSTS!!!
